WWIIReenacting.co.uk Forums
http://wwiireenacting.co.uk/forum/

.30 cal pintle diamentions?
http://wwiireenacting.co.uk/forum/viewtopic.php?f=112&t=72429
Page 1 of 1

Author:  LancEng156 [ Fri Dec 16, 2011 17:46 pm ]
Post subject:  .30 cal pintle diamentions?

Has anyone got a .30 cal pintle handy they could do the following measurements for me at all please :D

Image

Cheers
Danny

Author:  dave1SLANR [ Sat Dec 17, 2011 0:24 am ]
Post subject:  Re: .30 cal pintle diamentions?

Hope this makes sense

Starting from the top of the pintle the Dia is 32.99mm
The bottom of the first section Dia 27.61mm
The first gap is 3.76mm wide
The top of the second section Dia 26.38mm
The bottom of the second section Dia 23.99
The gap is 6.25mm wide
The end of the pintle shaft is Dia 20.96mm

So it tapers down from 32.9mm to 20.96mm the overall length of the pintle shaft is 67.98mm

Not trying to tell you how to do it :) ,coz I bet your an engineer :lol: but if you taper it first and then just slide a micrometer down the taper to 27.61mm you've got to your first slot and so on :) , only reason I'm saying that is because I forgot to measure each section length :lol:

Author:  LancEng156 [ Sat Dec 17, 2011 1:53 am ]
Post subject:  Re: .30 cal pintle diamentions?

Cheers for your help Dave,

Bought a dash mount a few years ago and measuring the upper inner dia. its 57.5mm!

Think I'll have a machine a sleeve :?

Cheers again,
Danny

Author:  dave1SLANR [ Sun Dec 18, 2011 2:25 am ]
Post subject:  Re: .30 cal pintle diamentions?

Hi Danny

57.5mm sounds like the same size as my Jeep M31C mount that takes the type of pintle in the picture, is your dash mount the same as the one in the other picture ?

Dave

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/